Friday, May 1, 2009

CCNA lab

CCNA Certification

The Cisco CCNA network associate certification validates the ability to install, configure, operate, and troubleshoot medium-size routed and switched networks, including implementation and verification of connections to remote sites in a WAN. This new curriculum includes basic mitigation of security threats, introduction to wireless networking concepts and terminology, and performance-based skills. This new curriculum also includes (but is not limited to) the use of these protocols: IP, Enhanced Interior Gateway Routing Protocol (EIGRP), Serial Line Interface Protocol Frame Relay, Routing Information Protocol Version 2 (RIPv2),VLANs, Ethernet, access control lists (ACLs)
    * 1 Console Login
    * 2 Router Configuration
    * 3 Examine the Router
    * 4 Copy to a TFTP server
    * 5 Copy from TFTP server
    * 6a Clear the backup config
    * 6b Saving the backup configuration
    * 7 Copy to NVRAM
    * 8 Initial router configuration
    * 9 Initial Switch Configuration
    * 10 RIP routing
    * 11 IGRP routing
    * 12 Create Accesslist
    * 13 IPX Access List Security
    * 14 IPX router configuration
    * 15 IPX SAP filtering
    * 16 Limitting VTY address
    * 17 Load 2600 OS
    * 18 Navigating the IOS
    * 19 Password recovery
    * 20 Telnet to a remote Router

1 comment:

  1. 1st time i read this type of suggestion some time's before i read about Cisco ccna lab kit something different between this two blog.

    ReplyDelete

quocvuong_it@yahoo.com